- News -
Matters needing attention in the use of pneumatic clutch
Implicated rotation of 1. cylinders
The cylinder and piston parts are locked by the action of the bearing, and are fixed or stopped with 3 45 degree slots or Z-M threads. But to stop properly, not because the external interference force makes the cylinder leaning, slanting and work abnormally.
2. pay attention to the installation on the shaft
When installing the clutch on the shaft, use the special tools to pressurize the hollow shaft tube as much as possible, and don't impact the cylinder or other vulnerable parts.
Shaft end installation of 3. pulley and gear
The radial force center with wheel or gear can align the bearing center of the two sets of bearings in the flange as far as possible, and the over bias will affect the service life of the product.
4. bearing correlation
Generally used sealed bearings, maintenance free, a few parts should be based on the relationship between the use of the environment, usually 1 to 6 months to properly add grease to maintain.
5. avoid overload operation
As far as possible, the safety factor of the torque is 1.5 to 2 times as much as possible when the product is chosen. Overload will cause the tooth surface damage or reduce the service life.
The cylinder and piston parts are locked by the action of the bearing, and are fixed or stopped with 3 45 degree slots or Z-M threads. But to stop properly, not because the external interference force makes the cylinder leaning, slanting and work abnormally.
2. pay attention to the installation on the shaft
When installing the clutch on the shaft, use the special tools to pressurize the hollow shaft tube as much as possible, and don't impact the cylinder or other vulnerable parts.
Shaft end installation of 3. pulley and gear
The radial force center with wheel or gear can align the bearing center of the two sets of bearings in the flange as far as possible, and the over bias will affect the service life of the product.
4. bearing correlation
Generally used sealed bearings, maintenance free, a few parts should be based on the relationship between the use of the environment, usually 1 to 6 months to properly add grease to maintain.
5. avoid overload operation
As far as possible, the safety factor of the torque is 1.5 to 2 times as much as possible when the product is chosen. Overload will cause the tooth surface damage or reduce the service life.